General

How do I install the Azuga Fleet device in my vehicle?
1. Write down the serial number of the device and the vehicle name where the device is to be installed. (See the pre-install checklist that is included ...
Tue, Feb 14, 2017 at 1:41 AM
How do I check if my Azuga device is working?
1. Re-seat your device.  Remove the device and plug it back into the OBD port of your vehicle. If the device works fine, then all the LEDs will flash on...
Tue, Feb 14, 2017 at 1:40 AM
Azuga Fleet Device - Cheat Sheet
1. Device Installation a. Locate your vehicle’s on-board diagnostic (OBD) port. The port is generally located under the bottom edge of a vehicle...
Tue, Jul 11, 2017 at 12:09 AM
Azuga device LED does not blink when plugged into my vehicle.
1. Unplug and plug the device back into the vehicle after 30 seconds. When the green light on the device is solid, turn ON the ignition and drive around fo...
Tue, Feb 14, 2017 at 2:07 AM
Where is my vehicle's OBD Port located?
To locate the OBD port in your vehicle, click the link below and provide your vehicle details.  http://fitguide.installernet.com/allstate/ ...
Thu, Mar 3, 2016 at 8:38 PM
Do all devices report a Disconnect event in real time?
Only a device with an inbuilt capacitor or battery has the capability to send messages in the real time when it gets removed from a vehicle.  These ...
Mon, Jul 25, 2016 at 12:33 AM