How do I install the Azuga Fleet device in my vehicle?

Modified on Fri, Dec 29, 2023 at 8:11 AM

1. Write down the serial number of the device and the vehicle name where the device is to be installed. (See the pre-install checklist that is included in the shipping carton). 


2. Locate the on-board-diagnostic port (OBDII port) of your vehicle and plug the Azuga device into the diagnostic port (refer to the figure below). The port is generally located under the bottom edge of a vehicle’s dashboard (on the driver’s side).




3. Wait for two minutes and start your vehicle. 


4. Allow the vehicle to be in the idle state for 2-3 minutes. 


The LED on the device starts flashing, indicating the device’s connection with the vehicle. It also indicates the GPS location fix and communication with the Azuga website. First, the LED will be green indicating the device connection. Then it turns amber, indicating GPS location fix and finally it will be red, indicating that the communication has been established. The LED will blink once during subsequent trips and all the trips get logged in our system. 



Last Verified on Dec 2023



Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons

Feedback sent

We appreciate your effort and will try to fix the article