You can install an auxiliary camera on different spots of the vehicle to enable tracking during trips. Once installed, you can associate an auxiliary camera with a single main AI-12 dashcam through the web interface.
Power connector: This is a round power barrel connector socket to power the camera. Ideally, this requires a 12V DC power supply - 5.5 x 2.1mm (no pin)
Restore connector: Once powered on, hold the restore button down for 10-20 seconds to reboot the aux camera to reset the settings to factory default. You must not remove the restore button cable as it is the only way to return the camera to factory default on the occurrence of an issue.
Ethernet connector: This connector connects the camera with an ethernet connector and can be removed if needed.
(Note: Cutting the ethernet connector cable must be done after the point where the initial cable splits into 3 cables)
